 |
Wynns Red Gasket Maker makes seals gaskets 200ml 10807
Wynns Red Gasket Maker makes seals and gaskets 10807
Wynn’s Red Gasket Maker is a flexible high-temperature resistant, watertight filling and bonding material. It is a polysiloxane based product in a pressure cartridge for making seals and gaskets in a rapid and easy way.
- Is resistant to oils, transmission fluids, water, antifreeze, grease, smoke and hot toxic gases.
- Replaces cork, felt, paper and rubber gaskets.
- Withstands low temperatures up to -40°C (continuous) and high temperatures up to 232°C (continuous) and 260°C (intermittent).
- Does not harm catalytic converters and electronic sensors.
- Retorquing is not necessary after complete curing.
- No mixing required (single component).
Applications
Ideal for replacing seals and gaskets of engine components (cylinder-head cover, transmission and oil crankcase, water pumps, thermostats), light fittings, heating installations, AC, bodywork, industrial ovens, cooking stoves, window seals and many other applications.
- The product is not suitable for replacing head gaskets nor for applications that require continuous immersion in petrol.
- Do not use in joints deeper than 10 mm.
- Avoid contact with solvent cleaners during cure.
Directions
- Remove plastic tear- off lid.
- Remove cap from nozzle.
- Ensure that surfaces are clean, dry and grease free.
- Turn the top clockwise until you hear a click.
- Now turn further clockwise till stop to open trigger completely.
- Turn to Max for a thicker bead and to Min for a thinner bead.
- Apply the Gasket Maker by lightly pressing the trigger and drawing the bead along.
- Immediately assemble parts.
- Hand tighten until product begins to squeeze out around the flange.
- Allow to cure for one hour, then retighten 1⁄4 to 1⁄2 turn.
- Gasket will skin over in one hour and fully cure in 24 hours.
- After use, wipe the nozzle clean and put back the cap.
- If product has cured in the nozzle, loosen nozzle and remove cured product.
- If the application is one in which the components are to be dismantled after the gasket has been made, apply the Gasket Maker normally, but spread a light coating of oil to the opposing face of the joint before bringing the two surfaces together.
Supplier Code: 10807
E and M Code: 10807WYN
Price(Exc.VAT): £11.08
Quantity Available: 0
Minimum Postal Charge: Royal Mail Large Packets £5.50
Sorry this product cannot be added as it is temporarily out of stock, please call the shop for availability...
When will this be back in stock / Information Request
Category: Workshop Consumables / Sub Category: Glues Sealants and Threadlocks
|